#STEMCO KAISER KING PINS PDF INSTALL#
#STEMCO KAISER KING PINS PDF DRIVER#
#STEMCO KAISER KING PINS PDF CODE#

Fax: 98 Cross section of bushing lip seal.QWIK KIT PLUS KIT OEM KIT # AXLE CODE APP.

STEMCO Kaiser IS NOT RESPONSIBLE FOR ANY INJURY THAT MAY OCCUR DURING THIS PROCESS.Ĥ641 Industrial Drive, Millington, MI 48746

WARNING: STRIKING STEEL PARTS WITH HAMMERS CAN RESULT IN CHIP PROJECTILES, ALWAYS WEAR SAFETY GLASSES TO PROTECT YOURSELF AGAINST USE THE STEMCO Kaiser TECHNICAL SERVICE LINE If unit seems loose or too tight we recommend calling.There should be very little up and down movement.Once greased the spindle should turn easily from side.Apply grease until it can be seen between axle and.

#STEMCO KAISER KING PINS PDF INSTALL#

Install grease fitting into end plate or end plug.Install end plates or end plugs, using the proper seal.Pound lock pins into place, lock pins with threads.Position lock pin flats on pin so they line up with lock.Once the bearing fit is correct, allow pin to slip into.If bearing is too tight or too loose, adjust the number of.Tap bearing into place, a properly fit bearing will requireĪ slight tap fit without damaging the bearing case.Place spindle, shims and pin onto axle, allow pin to.Through needed shims, be sure TOP of pin is parallel to axle for proper lock flat alignment. Position king pin through upper spindle bore and.Place needed shims under upper spindle bore.For proper bearing orientation please refer to figure #1.Simultaneously the spindle has spread and may need replacement. If pin fits through bushings individually but not.

Using king pin check for fit, first insert pin into eachīushing individually then insert pin into both bushings, king pin should slide through both bushings simultaneously.

#STEMCO KAISER KING PINS PDF DRIVER#

Using the Kaiser Plus bushing driver specificallyĭesigned for your kit, drive both bushings into bores.Seals into the bore leaving the seal flush with the axle side of each spindle bore. Using a bushing driver or similar device, drive the.Handle with care, lip seals are easily damaged.Remove any burrs from spindle bores and axle eyes.Clean spindle and axle eyes and wipe dry.Use established procedures for teardown.

Stemco kaiser king pins pdf